What reason is aperture slant small when twist drill is drilling? If the drill hole is not round, it is probably because the bit edge belt has been seriously worn down. In this case, all you have to do is to change the drill bit or to polish the drill bit. What reason is the […]
The drill bit is semi-closed cutting, and the heat of drilling is difficult to spread outward, so it is easier to form a high cutting temperature. Therefore, the main cause of bit wear is thermal wear, for high-speed steel bit, mainly phase change wear. In addition, there are contact fatigue, excessive deformation, edge breaking, brittle […]
Drilling methods: Before drilling, the workpiece plane should be leveled. No convex platform is allowed in the center to facilitate the correct centering of the twist drill. Align the tailstock so that the center of the twist drill is aligned with the axis of rotation of the workpiece. Otherwise, the diameter of the hole may […]
Selection of Cutting Fluid in Drilling Material for twist drills Material to be drilled low carbon steel medium-carbon steel hardened steel High Speed Steel Twist Drill Use 1%~2% low concentration emulsifier, electrolyte aqueous solution or mineral oil Use 3%~5% medium concentration emulsifier or extreme pressure cutting oil Use extreme pressure cutting oil Cemented carbide […]
How to grind the worn bit by hand? First of all, we should observe the wear of the two main cutting edges of the drill. If the degree of wear on both sides is different, the wear on one side is slightly higher than that on the other. More attention should be paid to grinding. […]
The grinding quality of twist drill directly affects its drilling quality. So the grinding of twist drill is very important. There are two kinds of grinding conditions for twist drills: 1) correct grinding and 2) incorrect grinding. The impact of these two conditions on workpiece processing is described below. 1. Correct grinding Drilling condition: When […]
Choosing the right geometric angle of the graphite tool can help to reduce the vibration of the tool. In turn, the graphite workpiece is not easy to collapse. (1) Land Angle When the negative land angle is used to process graphite, the blade strength is good, the impact resistance and the friction resistance are good. […]
In the case of constant cutting parameters, in order to improve production efficiency and reduce production costs, the tool coating technology to reduce tool wear, and in order to improve tool durability has become a trend. Tool coating refers to coating a thin layer of refractory metals or non-metallic compounds with good wear resistance on […]
In order to ensure the quality and safety of drilling, different clamping methods should be adopted according to different shapes of workpieces and cutting forces. (1) The workpiece with a flat shape can be clamped with a flat-jaw clamp, as shown in Figure (a). (2) For cylindrical workpieces, V-shaped iron can be used for clamping, […]
According to the machining characteristics of the material, the drill bit is required to have the following characteristics: the hardness of the drill bit must be greater than the hardness of the workpiece to be processed. Because the bit bears a lot of torsion and axial force when machining the workpiece, it must have enough […]
